Hey guys, I will have to double check on Monday, but I am going to have to say that it is not installed, but just a folder in my home directory.
As for the component in general, I went ahead with some test and tune, looks awesome for sure. Only question I have though, in regards to the homing sequence, if the Carousel is not homed, and I set "enable" true, it should stop rotating when it sees the sense.0 pin "home position" go true, then report back out on the carousel.0.current-position as being pocket 1 correct? And this should be done with out telling it go to pocket 1 on the carousel.0.pocket-number input during the homing routine? Reason I ask, the only way I could get it to stop on the home position switch " pocket 1" during homing, was to use an assignment block in my ladder logic that I set to "1", at the same time I start the carousel homing sequence. Then it works as intended I believe. Rick -------- Original Message -------- Subject: Re: [Emc-users] Carousel Component From: "andy pugh" <[email protected]> Date: Fri, October 30, 2015 1:22 pm To: "Enhanced Machine Controller (EMC)" <[email protected]> On 30 October 2015 at 16:10, Rick Lair <[email protected]> wrote: > I don't have the dev package installed, I just downloaded it, to get to > the remap stuff. There is scope for confusion here. linuxcnc-dev is a package that can be downloaded from the package manager, either through the synaptic gui or with sudo apt-get install linuxcnc-dev However, if you download the LinuxCNC source code, that generally ends up on a folder also called linuxcnc-dev. But you can have either one without the other. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
