There is a forum on "Practical Machinist" just for Monarch lathes of all styles. Probably your best bet for info on getting it back on its feet.
I have a 10EE of early '50s vintage which is probably a completely different animal in the drive department as it has a high(direct) and low(back gear) range each of which is continuously variable. http://www.practicalmachinist.com/vb/monarch-lathes/ Go there and register. You will be asked a lot of questions before you start getting any answers because from the info you have given there is no way to tell which machine you have. Good luck, Cecil ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. http://sdm.link/zohomanageengine _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
