> On 06/19/16 17:55, Nicklas Karlsson wrote:
> > I tried to tune parameters manually but most of the time is spent either in
> > short circuit or open circuit,
> this is called 'hammering'
> it actually works but for a poor reason.
> if the tools is too far away, you are open
> if the tool is too close, it is shorting
> For a brief time in transit between these 2 states you DO achieve the
> proper position
> and you get _some_ sparks.
>
> the idea is to find the ideal position where sparks occur easily
> yiu can find this if you can control the 'edm servo'.
Then I now how it should look. I didn't expect something good with my Lego
prototype without proper tuning and to low ignition voltage at the first run.
> ...
You provided exactly the information I needed, thanks!
Regards Nicklas Karlsson
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports. http://sdm.link/zohomanageengine
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
