Does the 7I90HD work with Linux CNC? It looks like it could work It looks like it would be the board to use with an ARM Pi3. It connects with the host using SPI which is easy to use in the Pi3 7I90HD is the lowest cost Mega FPGA board at only $59 so you could have the computer and Mesa card both for under $100 and the set of cards would fit in the palm of your hand.
There is an Ethernet version of the FPGA card too but it is much more expensive and SPI might be even faster as there is far less overhead. SPI can't go very far, just a few inches but What about labor problems as the ports? Spomthing like this would come in air freight. Almost all electronics On Sun, Oct 23, 2016 at 8:37 PM, Danny Miller <[email protected]> wrote: > > > On 10/23/2016 4:28 PM, Gene Heskett wrote: >> >>> No biggie, on my CNC (not an SBC) I just added a wifi USB already. >>> >>> Mesa 7i92 are totally available from the mfg: >>> >>> http://store.mesanet.com/index.php?route=product/product&product_id=30 >>> 2 >> Not according to that web page 2 hours ago. Out of stock. But this link >> say 170 on the shelf? Left hand, please call right hand. :) Either that >> or the boat finally docked, I understand they've got labor problems at >> some west side ports. > -- Chris Albertson Redondo Beach, California ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
