Hello! If we are talking about the Axis I have the same problem. And even more. I'm going to rewrite it in the near future.
Best regards, Pavel 23.12.2016 05:01, Jim Craig пишет: > I was running a program last night on my milling machine. I was cutting > air at the time and saw something that I did not like. I hit the stop > button in gmoccapy and the program stopped but then the tool plunged > downward in the z direction. I found this very odd. I took a look at the > tool offset and it was saying 0.000 in. Once again very odd. I played > around with it for a little bit and found that when I hit stop then the > tool length offset would be removed. Then this caused the machine to > plunge for some reason. > > Luckily it did no damage since I was far enough above the part to not > cause a crash. > > I have tried to reproduce this same behavior in a sim configuration in > 2.7.8 but I cannot 100%. If you change the G49 G43 option the tool will > show as moving on the screen but it is moving instantly as the change is > being made. No real plunge occurring, or is it? Was this a glitch in > 2.7.4? If not what could cause this behavior? > > Thanks, > > Jim > > > ------------------------------------------------------------------------------ > Developer Access Program for Intel Xeon Phi Processors > Access to Intel Xeon Phi processor-based developer platforms. > With one year of Intel Parallel Studio XE. > Training and support from Colfax. > Order your platform today.http://sdm.link/intel > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today.http://sdm.link/intel _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users