Pavel, I believe this has been fixed in a version of linuxcnc more recent than 2.7.4. I have tested it in simulation and it appears to be fixed. I am going to update my actual machine today and try it out to see if it has fixed the problem. My issue was in gmoccapy not axis. I am not sure if it affected all guis or not.
Thanks, Jim On 12/25/2016 10:43 PM, Pavel G. Kasyanenko wrote: > Hello! > > If we are talking about the Axis I have the same problem. And even more. > I'm going to rewrite it in the near future. > > Best regards, > Pavel > > 23.12.2016 05:01, Jim Craig пишет: >> I was running a program last night on my milling machine. I was cutting >> air at the time and saw something that I did not like. I hit the stop >> button in gmoccapy and the program stopped but then the tool plunged >> downward in the z direction. I found this very odd. I took a look at the >> tool offset and it was saying 0.000 in. Once again very odd. I played >> around with it for a little bit and found that when I hit stop then the >> tool length offset would be removed. Then this caused the machine to >> plunge for some reason. >> >> Luckily it did no damage since I was far enough above the part to not >> cause a crash. >> >> I have tried to reproduce this same behavior in a sim configuration in >> 2.7.8 but I cannot 100%. If you change the G49 G43 option the tool will >> show as moving on the screen but it is moving instantly as the change is >> being made. No real plunge occurring, or is it? Was this a glitch in >> 2.7.4? If not what could cause this behavior? >> >> Thanks, >> >> Jim >> >> >> ------------------------------------------------------------------------------ >> Developer Access Program for Intel Xeon Phi Processors >> Access to Intel Xeon Phi processor-based developer platforms. >> With one year of Intel Parallel Studio XE. >> Training and support from Colfax. >> Order your platform today.http://sdm.link/intel >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > ------------------------------------------------------------------------------ > Developer Access Program for Intel Xeon Phi Processors > Access to Intel Xeon Phi processor-based developer platforms. > With one year of Intel Parallel Studio XE. > Training and support from Colfax. > Order your platform today.http://sdm.link/intel > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today.http://sdm.link/intel _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
