On Sat, 18 Feb 2017, Tiklack wrote: > Date: Sat, 18 Feb 2017 12:19:05 -0500 > From: Tiklack <[email protected]> > To: emc-users <[email protected]> > Subject: [Emc-users] [utf-8] How to configure a basic system using Pncconf > > I have tried using Pncconf to configure a basic milling system: X,Y,Z axis, > 3 x home switches, 1 x all limit switch, spindle on/off output, Mesa 5i25. > The system is LCNC 2.7.8 on Debian.The break-out board is one of the common > Chinese type interfacing to 2M542 motor drives and stepper motors. I.e. an > open loop system. > > If you are looking into the generated HAL file there seems to be no signals > for step pulses? When a parallel port and Stepconf is used you get an > "xstep" signal connected to the step pulse input of the motor drive. It > seems like Pncconf in this case only generates servo systems, not open loop. > Could that be because Pncconf is a Beta version?
There are no stepgen step/dir pins in the hal file because hardware stepgen output pins are not directly controlled by software as they are in a parallel port configuration. Peter Wallace Mesa Electronics ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
