On 02/27/2017 09:35 AM, Gene Heskett wrote: > > And, I just checked, formatted the .list file entry according to the > wheezy entries at http://buildbot.linuxcnc.org/ and there is not an > entry in the repos to match a wheezy i386 install, which this is because > yonks ago, when I installed wheezy, lcnc didn't run on 64 bit installs, > so I've been running an i386 install, with whichever kernel had an > actually works PAE, without which I'm a gigabyte into swap in just a few > hours. The error message from apt-get update is: > > W: Failed to fetch http://linuxcnc.org/dists/wheezy/Release Unable to > find expected entry '2.7-rtpreempt/binary-i386/Packages' in Release file > (Wrong sources.list entry or malformed file)
Unfortunately the apt sources for the buildbot and for the main archive at www.linuxcnc.org use slightly different URLs. The "2.7-rtpreempt" component you're using is for the buildbot, not for www.linuxcnc.org. The matching component on www.linuxcnc.org is "2.7-uspace". The apt source line should look like this: deb http://linuxcnc.org/ wheezy base 2.7-uspace Here's the relevant docs, for reference: http://linuxcnc.org/docs/2.7/html/getting-started/getting-linuxcnc.html#_alternate_install_methods -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
