I would comment them out and test, I tested the first two... and yes the StepConf maintainer should remove ini items that are not used. You should start a issue on this, the issue tracker is the correct place to report things like this.
https://github.com/LinuxCNC/linuxcnc/issues JT On 3/30/2017 3:08 PM, Joe Hildreth wrote: > John, > > These entries were generated with stepconf, should stepconf be updated so as > not to include them. Also, just to verify, all three variable can be removed > from these two sections? > > [EMCMOT] section > COMM_TIMEOUT = 1.0 > COMM_WAIT = 0.010 > > [TRAJ] section > CYCLE_TIME = 0.010 > > > Joe Hildreth > > ----- On Mar 30, 2017, at 2:32 PM, John Thornton j...@gnipsel.com wrote: > >> You can comment them out and LinuxCNC runs just fine, that tells me they >> are leftover bit rot. >> >> JT >> > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
