On 06/05/2017 03:56 PM, Stuart Stevenson wrote:
Gentlemen,
Debian Wheezy
latest linuxcnc release - installed today - but the last release did the
same thing
Axis interface
Kasuga 3 axis mill
when starting (run from here) on line 310 I get the error "length of cutter
compensation entry move is not greater than the tool radius"
The message clearly indicates the interpreter thinks cutter
radius comp is on.
if it executed the G41 on line N290 but then did NOT execute
the G40 on line N292, then it would still be in G41 offset
mode. Note the displayed modes on the GUI are provided by a
DIFFERENT interpreter that is not aware of the stop and run
from line. If you need to run from line, it might be safest
to insert a line with a G40 there, and run from that line to
be sure the offset is turned off.
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users