On 06/30/2017 08:08 AM, Stuart Stevenson wrote:
Gentlemen,
Here is the comp file from the B axis of the blue cincinnati at MPM.
-32.0 .041 .045
<snippage>
22.0 -.014 -.030
I started the compensation two degrees past the travel on both ends so the
compensation would be applied (my intention anyway) for the entire travel
range.
I comped it every 1 degree. The increment could have been more or less I
just chose 1 degree and liked the results.
As you can see the numbers are positive and negative but I don't remember
how the sign affected the compensation.
Easy to figure out. Comp the machine and check it. If the error is twice
what you were trying to fix then you have the sign wrong. :)
HTH
have fun
Stuart
Wonder if backlash comp could be used on the Z axis on my saw beveler to
compensate for a long skinny table that is off by a few thou here and
there over the entire length of the table?
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
