On 07/02/2017 09:11 AM, Les Newell wrote:
Yes, that's exactly what I'm looking for. Minor dips and humps in the
table that I'd like to have some software correction for. I only
have the two axes, X and Z on the machine. It's a saw beveler that
cuts a tapered triangular bamboo strip.
Wait a day or so. I am in the middle of writing kinematics that will
do exactly what you want to do. In my case it is to compensate for a
worn bed on my lathe. Roughly how many points are you likely to need
in your compensation table?
Les
I've got a bit of a weird setup in my beveler. Not really sure if
replacing the current mode of operations to run a different set of kins
will work without having to redo all the other stuff that runs currently.
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
