On Thu, 6 Jul 2017 16:13:47 +0100 Les Newell <[email protected]> wrote:
> I have been working on retrofitting my Hurco mill for the last couple of > days and I'm about ready to start setting up LinuxCNC. However I'm lost > as to the correct bit file and configuration options for a 7i80HD +7i48 > combination. > I have 7i80hd-16-sv12im-2x7i48 bitfile loaded and the 7i48 is on P1. I > have my I/Os on P3. > I'm not sure what my loadrt line should be. I got this far: > loadrt hm2_eth board_ip="192.168.1.121" config="num_encoders=6 > num_pwmgens=6" I got in the *.ini file: [HOSTMOT2_2] DRIVER=hm2_eth board_ip="192.168.1.11,192.168.1.10" BOARD=7i80 CONFIG="firmware=hm2/7i80-1.5/SVST8_8.BIT num_encoders=4 num_pwmgens=4 num_stepgens=8" And in the *.hal file: loadrt [HOSTMOT2_2](DRIVER) config=[HOSTMOT2_2](CONFIG) loadrt hostmot2 Then running with two cards, parameters are probably not useful for you but should give a hint. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
