Problem with the kinematics and it will move but not as expected?
On Fri, 28 Jul 2017 16:03:56 +0200 theman whosoldtheworld <bleachk...@gmail.com> wrote: > normally the first trouble is about your geometry and kins .... there are > some different version of kins on web. > The kinematic present in linuxcnc serves to simplify your life, but it is > not said to be the same as another one you might have taken into > consideration. > Fortunately, in the world, things can be done in many different ways .... > > bkt > > 2017-07-27 1:36 GMT+02:00 Charles Brauer <brauer.char...@gmail.com>: > > > I can't get the hal file right to run a stepper tripod. If someone could > > share one that runs on wheezy I would be most appreciative. I was thinking > > I could build a 3d printer with this. > > ------------------------------------------------------------ > > ------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
