All,
I am getting a "TRAM write error", and not finding much on it in a search. I am running lcnc 2.8.0-pre1, and using the Mesa 7i43 board. The error occurs when I physically assert the enable for the third axis. The first two axes came up fine, but if the only change I make to the configuration is to do an enable to the third amplifier, the error will occur. Is it perhaps related to the period of the servo loop? Thanks, Eric ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users