On 20 October 2017 at 02:43, Gene Heskett <[email protected]> wrote:
> Got that done, hooked it up and fixed the network (damned udev) and then
> ran the mills config. Exact same problem. That leaves me with a stack
> of bad 5i25's, or a config problem, but I have spent my time the last 3
> days disabling one or more functions at a time until I was clear down to
> nothing but the 3 axises. w/o effecting the problem.
You could try going even simpler. Test at the command-line
loadrt hostmot2
loadrt hm2_pci
setp hm2_5i25.0.stepgen.00.position-scale 1000
setp hm2_5i25.0.stepgen.01.position-scale 1000
setp hm2_5i25.0.stepgen.02.position-scale 1000
loadrt threads
addf hm2_5i25.0.read thread1
addf hm2_5i25.0.write thread1
start
setp hm2_5i25.0.stepgen.00.enable 1
{might need to setp a GPIO for enable here too)
setp hm2_5i25.0.stepgen.01.position-cmd 0.5
(and so on)
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
