On 15 March 2018 at 15:44, Todd Zuercher <to...@pgrahamdunn.com> wrote:
> I'm in Ohio, and the part I need is a mild steel adapter ring for the nose of > a spindle. It is 6.5 inches (165mm) diameter, and 10mm thick, center hole is > 96mm, and has two hole circles of 8 holes each. The outer circle is on a > 155.5mm circle and is tapped for 6mm screws, the inner circle is offset to > the outer one on a 115mm circle and is drilled and counter sunk for 6mm flat > head screws. I think I would get a laser-cut ring made, then true it up on a lathe and then mark-out and drill by hand. (though you could probably spot the hole locations on one of your routers) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
