rOn Wed, 28 Mar 2018, Marius Liebenberg wrote:
Date: Wed, 28 Mar 2018 15:15:05 +0000
From: Marius Liebenberg <mar...@mastercut.co.za>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: [Emc-users] One servo system
Hi all
I have to put together a system that will use one servo to drive a small
platform over a distance of 6m at a speed of about 25km/h or 8m/s or there
about.
I feel that using a full computer and mesa card for just one axis that does
not need a display sounds a bit excessive. The question is what are the other
options if any.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
If its just one axis can't you do this entirely with a servo drive capable of
position mode moves?
Peter Wallace
Mesa Electronics
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
