Are the bushings actually brass or are they perhaps aluminum bronze? > -----Original Message----- > From: Marius Liebenberg [mailto:mar...@mastercut.co.za] > Sent: Monday, April 02, 2018 10:24 AM > To: Enhanced Machine Controller (EMC) > Subject: [Emc-users] What RPM > > Hi > I have had this piece of machine in the store for a long time. I think it > was > used to decant fishing line to the smaller plastic reels. > I have a need for a small dedicated lathe that will onpy cut soft materials > like > plastic and aluminium occasionally. > The spindle in the picture is what is currently fitted to the machine and I > would like to refurbish and use it. The question I have is what RPM will I > be > able to run the spindle seeing that it uses these brass bearings? > > > > ----------------------------- > Regards / Groete > > Marius D. Liebenberg > +27 82 698 3251 > +27 12 743 6064
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
