On Fri, May 4, 2018, 05:05 andy pugh <bodge...@gmail.com> wrote: > On 4 May 2018 at 03:29, jeremy youngs <jcyoung...@gmail.com> wrote: > > >> I get this message no matter what I tell pnc it is. 5i25,7i43 etc . All > >> give me the same you haven forgot to assign pwm/ step to x,y,z, axis. > > Have you actually assigned a stepper or pwm to each axis? > Yes, several times , even when pnc assigns the pins itself it still says I did not assign them.
> It has never let me get to figure 8 . I have assigned pins for x,y,z, and > spindle pwm and encoders , launch test panel button does not have any > effect. And I am using the accept component changes Button. As far as I understand these docs, I have done everything > necessary. > In this page: > http://linuxcnc.org/docs/devel/html/config/pncconf.html#_mesa_i_o_setup > > What do you have? I'm not sure I understand this question. I'm on my first cup of joe so maybe it's me 😀 It > could be on any connector but you do need to have > something trying to output the drive command for each axis. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users