Perhaps we should now change the subject line for this topic? > -----Original Message----- > From: Nicklas Karlsson [mailto:nicklas.karlsso...@gmail.com] > Sent: July-26-18 2:08 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] CAD for LinuxCNC > > > On Wed, 2018-07-25 at 18:49 +0100, andy pugh wrote: > > > On 25 July 2018 at 18:26, Valerio Bellizzomi <vale...@selnet.org> wrote: > > > > > > > I'm not a python programmer. > > > > > > Nobody is until they start. > > > > > > (Not a glib answer, I have taught myself both C and Python to work on > LinuxCNC) > > > > > > > > > I don't think you want a program by an inexperienced programmer at first > > start, the quality control work would be overwhelming. > > I found the new software libraries for micro controllers peripherals are rather > complex to those I tend to write. But I am old and guess the new > programmers are young. > > The methods they use may make in a totally dynamic environment but > neither software nor hardware is dynamic so I prefer to remove complexity. > > ---------------------------------------------------------------------------- -- > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
