Good job reviving that old Anderson router. I for see one problem with a fully automated touch off routine like that, what do you do with a very large diameter tool that might miss the touch probe, such as a fly cutter for surfacing the fall board.
Were you able to reuse the old Fanuc drives and motors? Todd Zuercher P. Graham Dunn Inc. 630 Henry Street Dalton, Ohio 44618 Phone: (330)828-2105ext. 2031 -----Original Message----- From: John Dammeyer <[email protected]> Sent: Tuesday, August 28, 2018 7:06 PM To: 'Enhanced Machine Controller (EMC)' <[email protected]> Subject: Re: [Emc-users] Just in case anyone is interested in my tool changer... Very very cool. Your tool sensor is on the end of a pneumatic ram? It moves down slightly when touched. Is that when it makes contact? It doesn't look like the ram moves down. Just the sensor. How do you calibrate the tool sensor? Thanks John Dammeyer > -----Original Message----- > From: Les Newell [mailto:[email protected]] > Sent: August-27-18 1:44 PM > To: [email protected] > Subject: [Emc-users] Just in case anyone is interested in my tool changer... > > I uploaded a quick video of it in action > <https://youtu.be/XI90PuKW6Mw> > > Les > > > ---------------------------------------------------------------------------- -- > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
