On Tuesday 29 October 2019 17:17:11 Gene Heskett wrote: Well it turns out that it cannot be done using the 7i76D, so I've got to move that signal to a sainsmart bob in order to actually get a logic 1=5 volts control. Nothing I can do to prevent the default pulled up outputs from running the pump wide open if power is applied to the interface box from any src.
An from what I observed, which was the motor alternating between stuck and a goodly number of rpms at a duty cycle of .45. Below .43 it doesn't run at all. So I need a longer on time to overcome friction and inertia, which translates to a much lower rep rate than 2000. Since I can't adjust that independently, it will have to be a separate sw module, sent to a gpio in p2 territory of the 5i25. Not an unfixable problem, but study time. Not made any easier by a recent update that killed my ability to print from other than this machine. Shared printers, theres 5 profiles marked shared that are not visible on any other machine on the net. Anybody have a clue what thats all about? I'm plumb bumfuzzeled. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
