I don't think so but I am trying now. I tested the vfd first taking PCWs advice and just put a pot on the anolog input and buttons to switch between LI1 and +24 in the vfd for forward rotation.
reverse rotation was just switching between LI2 and +24. Is it possible to just change the hal a bit and use it as is? I am using linuxcnc 2.8 and linuxmint any ideas would be great. also any way to check the state of the enable and direction spindle outputs would be nice to see what i am actually getting currently. regards Andrew On Mon, Mar 16, 2020 at 11:55 PM andy pugh <[email protected]> wrote: > On Mon, 16 Mar 2020 at 23:31, andrew beck <[email protected]> > wrote: > > > I currently have the 7i76 spindle enable pin switching the forward pin on > > the vfd > > the spindle direction pin on 7i76 switches reverse pin on vfd > > Can you configure the VFD for "On" and "Direction" rather than "fwd" > and "reverse"? > > The 7i76 outputs rather assume the former. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1912 > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
