On Thu, 9 Apr 2020, Horv?th Csaba wrote:
Date: Thu, 9 Apr 2020 17:49:28 +0200
From: "[UTF-8] Horv?th Csaba" <hcs....@gmail.com>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: [Emc-users] WHB04 MPG
Dear Everyone,
I have a milling machine. To this machine I connected a WXHC-HB04 MPG. I need
help for the configuration.
I operate the machine through MESA 7i92+7i33 control card. (Linuxcnc 2.9 pre)
I set up everything. Also the MPG is operating. But if I operate it through
MPG, the axes are jerking.
While using MPG, how can I set up acceleration and decceleration in
configuration (slower acc/decc)?
Best regards,
Csaba
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Typically this has been handled by low pass filtering the jog count
but there is now a separate jog acceleration constraint in motion:
(from the motion manual page)
axis.L.jogaccelfraction IN FLOAT
Sets acceleration for wheel jogging to a fraction of the ini max_acceleration
for the axis. Values greater than 1 or less than zero are ignored.
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
