On Tue, Jun 2, 2020, 20:09 Gene Heskett <ghesk...@shentel.net> wrote:
> On Tuesday 02 June 2020 18:22:20 Chris Albertson wrote: > > > Cura has about 200 settings that you can change. You might try > > printing on a raft or using say 50% infill density and Gyroid pattern > > I print small gears with 1.6 wall thickness. Slowing the speed to > > 30mm/sec works some times > > > That last was so disappointing that I now have a 12 tooth gear, with a > hub 12mm high, printing at 30mm and 100% infill. That of course > disclosed that I wasn't anywhere near close enough to the bed for > adhesion, so I raised the rear of it about a turn of the wheels. Then > it started sticking. But there so little spring left to lift the bed > that I'm going to modify the z switch to lower it another 1/8 ", which > will compress the springs and make them far more repeatable. > I found that cleaning the glass with alcohol and then giving it a spray of aquanet hairspray helped adhesion a lot. I usually had to let the glass cool completely to get the parts off. Dave > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users