See here <https://www.google.com/url?sa=i&rct=j&q=&esrc=s&source=imgres&cd=&cad=rja&uact=8&ved=2ahUKEwiXvrLK47fqAhXhxoUKHeHJCocQjRx6BAgBEAQ&url=https%3A%2F%2Fwww.pferd.com%2Fmedia%2FPDF-en%2Ftool-manual%2FPFERD-tool-manual-catalogue-5-int-en.pdf&psig=AOvVaw1J7ANPuYQ-lE_o1s3bLL8E&ust=1594095741801759> ;
Pferd will usually have what you need. There are 6mm shanks On Sat, 4 Jul 2020 at 19:02, Gene Heskett <ghesk...@shentel.net> wrote: > Greetings all; > > Specifically, my inability to find a wheel in cbn similar to the $20 > dremel diamond disk, something with a 6mm or 6.35mm shank that would fit > in the er20 chuck on the 6040 mill. > > I'd like to put a prop under the front of my A axis to establish heel > clearance then rotate the chuck after touching it off straight up, to > the side angles needed to do the v-belt pulley John D. was asking about. > That or most any other shape an HSS lathe tool needs sharpened at. > Attacking HSS with diamond is a waste of time and burns up the expen$ive > diamond. > > I have a 4" cup cbn wheel, but the arbors are junk, so its contact isn't > true. At 3k revs, thats hard on the wheel by the time you can hear > contact. > > So where can I src a cbn wheel small enough to run at 10k+ revs in the > 6040's spindle? Nearly 2 hours of googling came up empty below 3". > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users