> On Thursday 16 July 2020 01:39:04 Bari wrote: > > > On 7/16/20 12:18 AM, Gene Heskett wrote: > > > But all that lumber padding under the head, supporting it because > > > the drive isn't, its not possible to see the spindle. IMO that needs > > > to be subject to an on-site inspection. That also could hide some > > > pretty bad table divots. To warrant that low an asking, something > > > has to be damaged and deemed non-repairable. > > > > There is another Mori on that site for even less > > > > https://hgrinc.com/productDetail/CNC/Used-Mori-Seiki-Mori-Seiki-Mv40-C > >NC-VMC/01200900002/ > > > > And its even hungrier at 35 kw. > > > The pandemic has killed lots of businesses. 1 out of 4 businesses near > > me are closing for good. I expect to see deals for the next year at > > least on just about everything. > > There is that effect too. Weeding out the machines that aren't earning > their electric billing.
That's certainly a problem if/then I want to run att full power connections to elecric grid will cost more than machines and that's before any periodic fee. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users