On Tuesday 02 March 2021 11:55:06 ken.stra...@gmail.com wrote:

> Interesting! At 0.8mm thick I wonder how stable the positioning (both
> X/Y and Z) of the board would be. BTW, it seems to be available from
> Amazon Canada and probably many other places:
> https://www.amazon.ca/VViViD-AirFuse-Microsuction-Black-250mm/dp/B078F
>BQ3FC
>
> -----Original Message-----
> From: Roland Jollivet <roland.jolli...@gmail.com>
> Sent: March 2, 2021 11:20 AM
> To: Enhanced Machine Controller (EMC)
> <emc-users@lists.sourceforge.net> Subject: [Emc-users] OT: pcb milling
>
> Has anyone tried this for holding down PCB's when milling?
>
> https://www.materialsampleshop.com/products/micro-suction-tape
>
> Roland
>
The times I have done pcb's on a mill, I've always made a melamine pallet 
with a projecting tightly into a table groove bottom, with a dozen or so 
0-80 flathead screws to hold the edge of the pcb, wedging it to the left 
front corner of the pocket made for that board. That way I have drilled 
half way thru the pcb for a thru hole, turned the board over and drilled 
from the other side, meeting in the center of the boards thickness with 
perfect registration. Auto location was to the center of a small brass 
pipe just out of the lower left corner and at a known offset. That mill 
died, and if I was to do it again today on the 6040, I'd have to invent 
a pinned location for the pallet because the extruded  bed is such a 
mess, off Z as much as 1/8". So obviously its not been tried.
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
>
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users


Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to