Can't turn down a deal like that! I only need three analog channels. Thank you! -- Ralph
On Apr 25, 2021 1:22 PM, "Peter C. Wallace" <p...@mesanet.com> wrote: CAUTION: This email originated from outside the Walla Walla University email system. On Sun, 25 Apr 2021, Ralph Stirling wrote: > Date: Sun, 25 Apr 2021 17:43:12 +0000 > From: Ralph Stirling <ralph.stirl...@wallawalla.edu> > Reply-To: "Enhanced Machine Controller (EMC)" > <emc-users@lists.sourceforge.net> > To: "emc-users@lists.sourceforge.net" <emc-users@lists.sourceforge.net> > Subject: [Emc-users] Analog servo system > > Getting back to my Realmeca C2 mill retrofit now. > I'm giving up getting the Fagor 8050 control going, > so plan on retrofitting with LCNC. > > I'd like to use ethernet to a NUC-type computer. > I'm looking at this chain of boards, but am not > sure about compatibility of some: > > Mesa 7i94 eight-port smart serial to Ethernet > -> 7i69 48 i/o sserial -> 7i33 analog servo (have already) > -> 7i84 32i/16o sserial > -> 7i73 pendant sserial > > My main concern is if the 7i33 will work with the > 7i69, and if latency will become an issue with > everything running over sserial and ethernet. > > The 7i94 is in stock at Mesanet, and the 7i69 > and 7i73 are in stock at Mesaus. Some other > approaches, like the 7i97, are not in stock. > > Thanks, > -- Ralph > I have a 7I97 with one bad analog channel for free if you want it Peter Wallace Mesa Electronics _______________________________________________ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
