I installed the LinuxCNC 2.8.0 Debian 10 Buster PREEMPT-RT ISO a few months ago direct from the downloads page (http://linuxcnc.org/downloads/ <http://linuxcnc.org/downloads/>). I can confirm that lspci worked for me.
> On May 4, 2021, at 3:58 PM, Ed <ate...@mwt.net> wrote: > > On 5/4/21 2:46 PM, andy pugh wrote: >> On Tue, 4 May 2021 at 20:06, Ed <ate...@mwt.net> wrote: >>> no such animal as lspci. >> Try "sudo lspci". Linux denies all knowledge of commands that you >> don't have the rights to. I have no idea why. > > > Comes back as "command not found " > >> >>> Is there another good way to find the ports? >> cat /proc/ioports >> if it is an onboard one. > > All ports shown have zero's. > > > This is on a fresh down load of 2.8.0 on a Dell Optiplex 755. > > > Maybe a bad install? > > > Ed. > > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
