ok gmccapy works with your setup. i have been just having a play for the last 10 mins. does your generators make actual G code that the backplot can see and that I can run as a program? and start with cycle start
currently its like there is no program just almost jogging going on behind the scenes On Fri, Jun 4, 2021 at 10:56 AM Andy Pugh <[email protected]> wrote: > > > > On 3 Jun 2021, at 23:44, andrew beck <[email protected]> wrote: > > > > might be another issue > > Start LinuxCNC from the command line and see if there are any error > messages. > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
