On Tue, 6 Jul 2021, andrew beck wrote:
Date: Tue, 6 Jul 2021 18:35:26 +1200
From: andrew beck <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: [Emc-users] spindle orientation help for a 7i77 card looking for
configs to study
hey everyone.
i have been messing around all day with my cnc mill trying to get spindle
orientation working so that I can get my toolchanger working
I found a video on youtube from Tallas83 that showed what I want to do but
he used a 5i20 card and 7i33 and I am having trouble converting it to a
standard 7i77 mesa card set up.
https://www.youtube.com/watch?v=EoXoOYSFY2Q
I got it to load the new config eventually had to change all the motion
pins to spindle.0 stuff but still getting a bit stuck when I issue a m19 r0
command the spindle locks but doesn't rotate. and I can see on my vfd that
the frequency reference is not getting through even though in the hal
configuration the hm2 analog 05 output is showing a value. If I switch
back to my old config it fires right up so hardware is fine.
Is hm2_5i25.0.7i77.0.1.spinena true?
(analog out 5 has a separate enable)
does anyone out there have this working that can help. I don't need too
much hand holding I think and I have played with linuxcnc for several years
now. just getting stuck up against a wall.
regards
Andrew
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
