On 2/7/22 14:44, Stuart Stevenson wrote:
Something is fishy between the Y values.
You have Y4.xxxx in the first list and Y0.xxxx in the full listing.
Yeah, that was really odd. Turned out to be the tool table had a Y-4.0
offset in it.
On Mon, Feb 7, 2022 at 2:39 PM Stuart Stevenson <stus...@gmail.com> wrote:
I see it in your gcode file listing
On Mon, Feb 7, 2022 at 2:39 PM Stuart Stevenson <stus...@gmail.com> wrote:
Where is the decimal point in the X value of "End=(X14444, Y0.8964)"?
I would say it is X1.4444 and expect this is a typo when you entered this
in the email.
On Sun, Feb 6, 2022 at 11:12 PM Andy Howell <a...@gamubaru.com> wrote:
We had been cutting with the same gcode when suddenly it came up with an
error:
Radius to end of are differs from radius to start:
Start=(X1.4208,Y4.8728)
Center=(X1.4208, Y4.8964)
End=(X14444, Y0.8964)
r1=0.0236
r2=4.0001
Its got to some config issue. The same file runs in the simulator just
fine. That r2=4 is curious. We are cutting in a jig using fixture G55.
We had touched off the Y by 4 inches to run the file again. That worked
fine. We more the Y back 4 inches and touched off again to set the G55
back to its actual 0,0 origin. When we ran the time, we started getting
this error.
This is the code in question. Its complaining about line N70.
%
(TEST PIECE 4IN)
(MY PROGRAM COMMENT)
(T1 D=0.2362 CR=0. - ZMIN=-0.11 - FLAT END MILL)
N10 G90 G94 G17 G91.1
N15 G20
N20 G53 G0 Z0.
(BORE6)
N25 T1 M6
N30 S18000 M3
N35 G55
N40 G0 X1.3853 Y0.8728
N45 G43 Z0.6 H1
N50 G0 Z0.08
N55 G1 Z0.0236 F20.
N60 G18 G2 X1.409 Z0. I0.0236 K0.
N65 G1 X1.4208
N70 G17 G3 X1.4444 Y0.8964 I0. J0.0236
Any ideas about what is wrong? We are running LinuxCNC 2.7.15.
Thanks.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
--
Addressee is the intended audience.
If you are not the addressee then my consent is not given for you to read
this email furthermore it is my wish you would close this without saving or
reading, and cease and desist from saving or opening my private
correspondence.
Thank you for honoring my wish.
--
Addressee is the intended audience.
If you are not the addressee then my consent is not given for you to read
this email furthermore it is my wish you would close this without saving or
reading, and cease and desist from saving or opening my private
correspondence.
Thank you for honoring my wish.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
