I think that the problem is the motherboard. I pulled the MOBO/CPU from another machine. Put it all back together and it is running like a champ now.
It's always a crapshoot with these new motherboards/cpus. They seem pretty iffy... keep trying them until one works. It's always been that way for as long as I can remember! Thanks! On Tue, Aug 23, 2022 at 12:07 PM Peter C. Wallace <p...@mesanet.com> wrote: > On Tue, 23 Aug 2022, Curtis Dutton wrote: > > > Date: Tue, 23 Aug 2022 11:44:54 -0400 > > From: Curtis Dutton <curtd...@gmail.com> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net > > > > Subject: [Emc-users] 6i25 PC spontaneous reboot > > > > So I had a power outage last week and it took out the PC of my cnc router > > when the power returned. PS died and took the MOBO with it. > > > > It was 7 years old so not a big deal. > > > > I upgraded to an MSI 320M PRO-VH with an AMD Athalon 3000G. > > > > I was previously running a 5i25 but this board doesn't have a PCI slot so > > (until the adaptor comes) I pulled a 6i25 from one of my other machines. > > > > My setup is a 6i25 with 2 7i85S boards attached. > > > > All power is supplied to the 7i85S boards via a separate 5v power supply. > > All the jumpers are set properly. They are set to standard defaults as is > > described in the manual. > > > > W1 down > > W2 down > > W3 down > > W4 up > > W5 up > > W7 down > > W8 up > > > > So far so good. > > > > I have everything booting up and the machine starts up and it appears > that > > all functions work properly. > > > > With the machine enabled and no motion commands going it works properly. > > However when I start jogging any of the axis the PC resets and then > > restarts. > > > > The spindle works properly (VFD controlled by USB) and doesn't cause the > > reset. IO works properly and the machine is enabled so the velocity loops > > are active meaning that the 6i25 is functioning properly. It has sat idle > > for hours with no reset. Once I jog it... after a few seconds it resets. > > > > Does anyone have any ideas about what could be occurring. I'm a bit > stumped > > here. > > > > Thanks, > > Curt > > Does it reset if power down the axis drives? > might be a EMI/noise/grounding issue. > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
