So I had a power outage last week and it took out the PC of my cnc router when the power returned. PS died and took the MOBO with it.
It was 7 years old so not a big deal. I upgraded to an MSI 320M PRO-VH with an AMD Athalon 3000G. I was previously running a 5i25 but this board doesn't have a PCI slot so (until the adaptor comes) I pulled a 6i25 from one of my other machines. My setup is a 6i25 with 2 7i85S boards attached. All power is supplied to the 7i85S boards via a separate 5v power supply. All the jumpers are set properly. They are set to standard defaults as is described in the manual. W1 down W2 down W3 down W4 up W5 up W7 down W8 up So far so good. I have everything booting up and the machine starts up and it appears that all functions work properly. With the machine enabled and no motion commands going it works properly. However when I start jogging any of the axis the PC resets and then restarts. The spindle works properly (VFD controlled by USB) and doesn't cause the reset. IO works properly and the machine is enabled so the velocity loops are active meaning that the 6i25 is functioning properly. It has sat idle for hours with no reset. Once I jog it... after a few seconds it resets. Does anyone have any ideas about what could be occurring. I'm a bit stumped here. Thanks, Curt _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
