Port #1 of my MESA 7i92H is connected to the PMDX-126 DB25. I reversed engineered that far east BoB. Here's the schematic.
http://www.autoartisans.com/mill/MACH3InterfaceBoB.pdf I have it connected to Port #2 of my 7i92H since my PMDX-126 can't do everything I want for Port #2. John > -----Original Message----- > From: Sam Sokolik [mailto:samco...@gmail.com] > Sent: September-09-22 6:39 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Acorn CNC > > I did a little video where I made a charge pump to work with one of those > cheap BOBs... > > https://www.youtube.com/watch?v=RErLu73-Xno > > On Fri, Sep 9, 2022 at 8:00 AM <m...@mattshaver.com> wrote: > > > On 2022-09-09 07:19, m...@mattshaver.com wrote: > > > > > I am in awe of Den-Mother Steve for his ability to make good > > > quality electronic stuff at a reasonable price! > > > > Oops! just realized this was emc-users, not the CAMS list (Chesapeake > > Area Metalworking Society http://www.cams-club.org/). I was trying to > > refer to Steve Stallings of Practical Micro Design > > (http://www.pmdx.com/). It's too early for me :) > > > > Thanks, > > Matt > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
