> From: Joe H [mailto:[email protected]] > I was curious about holding power using a worn Torque Rite air actuated > power drawbar on a mill with an R8 collet that I suspected was slipping. > I checked it by putting a piece in the R8 collet that had a 1/2 inch square > pocket that would accept a torque wrench. > Holding the brake or putting it in low gear gave me a value which I > compared to other machines with the same setup. > What diameter did the collet hold? What were the torque results? John
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
