what is the material? what is the endmill material? how many flutes? is it centre cutting tool or non-center cutting end mill?
I have always struggled on o-flute endmills and ramp or plunge (breaking the tip :( https://zero-divide.net/?&article_id=4307_plunging-and-ramping-recomendations-and-techniques On Fri, 14 Apr 2023 at 12:56, Nicklas SB Karlsson <n...@nksb.eu> wrote: > fre 2023-04-14 klockan 12:07 +0100 skrev andy pugh: > > On Fri, 14 Apr 2023 at 10:29, Nicklas SB Karlsson <n...@nksb.eu> wrote: > > > > > > > > Anyone have any suggestion about this? Decrease ramp angle? > > > > > > > Can you spiral down, making a hole slightly less than twice the tool > > diameter, so that only one side of the tool is engaged? > Yes it would be possible. > > If possible to convince CAM module in CAD software I could also plunge > into a hole with a diameter 2mm less than mill. > > > Nicklas Karlsson > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users