Homing is done according to HOME_SEARCH_VEL And HOME_LATCH_VEL Also to check the HOME_SEQUENCE
Check the docs, incredibly insightful <https://linuxcnc.org/docs/html/config/ini-homing.html#sec:homing-section> On April 2, 2026 3:33:51 PM GMT+08:00, [email protected] wrote: > > > > >Greetings - I recently downloaded the latest version of LinuxCNC and installed >it on my 30"x30" cnc machine that has a 20W laser. > >I have a parallel port that runs to a parallel port breakout board. There is >a home switch on each axis, whose operation if visible via led indicators on >the breakout board. The Z axis homes at location 4.000, the X and Y axis home >at 0.000. The Z axis homes, the X axis homes, but the Y axis refuses to move >toward 0.000 when homing. > >I have tried changing the sign on Scaling in the ini (or is it the hal file) >and the axis does move in the correct direction using the manual move buttons >in LinuxCNC. I have home set at 0.000, min limit a -1.000, max limit at >30.000". The led indicator is off unless the home switch is pressed - just >like the Z & X axis. > >I am out of ideas and would appreciate some guidance. >Kind regards, >David > > >David V. Fansler >S/V Dragon Fire >S/V Spirit of 76 >www.dv-fansler.com >[email protected] >YouTube "Sailing Solo at 70" > > > > > >_______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
