Hi together,
i try to run a slave (LAN9252) without using the EK1100 Bus Coppler.
/opt/etherlab/bin/ethercat slaves --> 0 0:0 PREOP + Generic
The Slave Index of the device is therefor 0
I get the following error in the terminal when i try to execute the program:
Fatal error: Starting EtherCAT subsystem failed:
ecrt_master_slave_config() failed while configuring slave 0:0
After this i want to use the alias addressing, but i cant change it
(also can't change it for EtherCAT Beckhoff modules)
/opt/etherlab/bin/ethercat alias -p0 100
Failed to read SII: Failed to write SII: Input/output error
the slave works without a problem when i use it at another position or
connect it after a EK1100
What can i do to use the slave at position zero without using the EK1100
coppler?
BR Mark
_______________________________________________
etherlab-users mailing list
[email protected]
http://lists.etherlab.org/mailman/listinfo/etherlab-users
