I *think* it's fine to take them apart, replace a module, and then clamp
them back together as long as you are not charging/discharging until
after they are clamped back together.
Jay
On 11/7/25 21:37, Mr. Sharkey via EV wrote:
Anyone have a take on releasing the compression holding a 10-module
stack of Gen2 leaf modules that are (at least) partially charged (not
full)? It's time to disassemble the pack in my Electrak and swap out two
under-performing modules. I know these modules swell up when charged,
but once charging is stopped, and they sit for a while, is it safe to
disassemble to the pack as-is, or should I discharge it?
If discharge, how much? A volts-per-cell (half module) value would be
useful.
_______________________________________________
Address messages to [email protected]
No other addresses in TO and CC fields
HELP: http://www.evdl.org/help/
_______________________________________________
Address messages to [email protected]
No other addresses in TO and CC fields
HELP: http://www.evdl.org/help/
