Thank you. I was looking at that as being empty. However, now when I send
an email I get an NDR =unknown user - so I guess I haven't set it up right
from the connector side
-----Original Message-----
From: Neil Hobson [mailto:[EMAIL PROTECTED]]
Sent: Monday, September 10, 2001 12:21 PM
To: MS-Exchange Admin Issues
Subject: RE: Testing an X400 connection
The admd field (the "a= " part you show below) is typically a single
space character. Have you entered this?
Neil
-----Original Message-----
From: Cris Vitsorek [mailto:[EMAIL PROTECTED]]
Posted At: 10 September 2001 17:28
Posted To: Sunbelt Exchange List
Conversation: Testing an X400 connection
Subject: Testing an X400 connection
I've created an X400 transport, and the x400 connectors in my two sites.
now according to a q article i should create a custom recipient with an
address type of x400 and sent a test email. However, I obviously don't
understand what is required to do this. The x400 address for my user in
email addresses properties is c=US; a= ;p=Co1; o=Corp1; s=x400test;g=1.
When I try to create a custom receipient I get the message that an admd
is required. What am I doing wrong? Thanks for any help
List Charter and FAQ at:
http://www.sunbelt-software.com/exchange_list_charter.htm
**********************************************************************
This eMail and any files transmitted with it are confidential and
intended solely for the use of the individual to whom it is addressed.
Any view or opinions presented are solely those of
the author and do not necessarily represent those of Silversands
or any of its subsidiary companies.
If you have received this eMail in error please contact the Support Desk
Immediately by telephone on 01202-360000 or on eMail at
[EMAIL PROTECTED]
**********************************************************************
List Charter and FAQ at:
http://www.sunbelt-software.com/exchange_list_charter.htm
List Charter and FAQ at:
http://www.sunbelt-software.com/exchange_list_charter.htm
