Network guy checked the switch.... 5 errors and no collisions since the last time the switch was down. Ports set to match the nic cards 100 MB and full duplex Auto
Thanks Rob .... back to the drawing board. -----Original Message----- From: Campbell, Rob [mailto:[EMAIL PROTECTED]] Sent: Friday, April 05, 2002 11:23 AM To: MS-Exchange Admin Issues Subject: RE: 5 hour delay btw receive and delivery If the timezone settings are correct, you might start looking for communiction problems between the servers. If it's a managed switch check the switch stats for errors on those 2 ports. If you see anything in the "Late Collisions" counters start looking for a duplex mismatch. > -----Original Message----- > From: Bob Falkenberg [mailto:[EMAIL PROTECTED]] > Sent: Friday, April 05, 2002 1:03 PM > To: MS-Exchange Admin Issues > Subject: RE: 5 hour delay btw receive and delivery > > > On a 100 MB switched network. They are sitting next to each > other in my > server room and are on the same switch. > > Bob F. > > -----Original Message----- > From: Campbell, Rob [mailto:[EMAIL PROTECTED]] > Sent: Friday, April 05, 2002 10:59 AM > To: MS-Exchange Admin Issues > Subject: RE: 5 hour delay btw receive and delivery > > > What kind of connector between the 2 servers? > > -----Original Message----- > From: Bob Falkenberg [mailto:[EMAIL PROTECTED]] > Sent: Friday, April 05, 2002 12:38 PM > To: MS-Exchange Admin Issues > Subject: 5 hour delay btw receive and delivery > > > Hello folks, > > Inbound STMP message received on Server1 at 12:17 AM per the message > tracking log. SMTP Inbound message is Transferred from the > Internet Mail > Service at 12:17 on Server1. Server1 expands Distribution > list and other > recipients. > > 2 messages are received from Server1 in the Server 2 MTA at > 5:46 AM. There > was a 5 hour gap between the time received and delivered. > > This is an Exchange 5.5 sp4 installation running on NT 4.0 > sp6. Server 1 is > OWA/IMC sever with 1gb of ram, dual 733 processors. Server 2 > is dual 733 > processors with 500 mb of ram an is the mailbox/public folder server. > Server 2 is running Scan Mail 3.51 and Server 1 doesn't run Scan Mail. > > Open to suggestions on where to start trouble shooting this one. > > > Bob Falkenberg > List Charter and FAQ at: > http://www.sunbelt-software.com/exchange_list_charter.htm > > > > List Charter and FAQ at: > http://www.sunbelt-software.com/exchange_list_charter.htm > > List Charter and FAQ at: > http://www.sunbelt-software.com/exchange_list_charter.htm > List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm
