>Eth0 is set to i/o 300, IRQ 10, eth1 is set to i/o 280, IRQ 11.
>This was done with the 3Com DOS utility. PnP was disabled at
>the same time. All IRQs are set to legacy in the BIOS, and
>PnP support is disabled.
With these cards it's necessary to physically remove power from the card
after getting everything set up. They have a power on routine which
reads the NOVRAM. Set them the way you want them with the DOS util,
shutdown and turn power completely off. If you have a newer machine with
a software controlled power supply physically unplug the box from the
wall and count to 10. Then boot it back up in DOS and use the utility
program to check that everything stays where you left it.
MB
