Does this server have two nic cards in it, one for one subnet and one for
the other subnet. If so, you can setup Linux to work like a router and
transfer packets from one subnet to the other. In SAMBA you can setup the
interface too use one workgroup but transfer the packets from one subnet to
the other. This will allow you to have shares on one subnet and the other
subnet can access them. I did this once and had it working until I got my
HUB, then I switched everything over to one subnet. Also, are you planning
to use SAMBA as a PDC controller for both subnets?

 -----Original Message-----
From:   Claudio [mailto:[EMAIL PROTECTED]] 
Sent:   Friday, February 09, 2001 4:21 PM
To:     [EMAIL PROTECTED]
Subject:        Re: [expert] Samba and two-class_network...


On Friday 09 February 2001 15:22, you wrote:
> You now see the way that tcp/ip works - you can only see the segements on
> the network in the same domain or class C address.
>
> You need to make the server available on both classes of address. You
don't
> explain how you link the different networks. Assuming they are on the same
> physical cable without any form of bridge - you can give your ethernet
card
> an additional alias so that it sees both networks. I've never done this,
> but I imagine that the Linux server will now act as a bridge to both
> networks,

> > Hi all,
> > I've the following problem: a print server using LM-7.2, Cups and samba.
>
> The
>
> > IP address is:
> >
> > SERVER: 141.108.21.3
> > ^
> >
> >
> >
> > My network has TWO classes of IP addresses: 141.108.16.x and
141.108.21.x
>
> Now
>
> > it happens that ONLY machine from class 141.108.21.x (the same of the
> > server!) may see the smb server, while the machines from 141.108.16.x
>
> cannot
>
> > see the server! Is it possible to avoid that? I'd like to let all of the
> > machine see the printers!!!
> >
> > Thanks, Claudio

Indeed we have quite a big LAN. The two "C" classes are controlled by a
Cisco 
Router, and they are mixed on the same cable anyway... It's a campus
network, 
can you understand what I mean?  :-)

        Claudio

Reply via email to