Hash: SHA1
Lars Ole Christoffersen wrote:
|HI
|I performed a harware upgrade on a mandrake 9.0 installation. Here is
|the situations before and after:
|
|Before:
|ASUS (older) mother board with two USB 1.0 access points. USB working
|well.
|PIII processor
|
|After:
|ASUS P4S8X motherboard with 4 USB 2.0 access points. USB not working
|properly.
|
|What happens is the following: During startup I am told that it was not
|possible to modprobe: insmod usb-ohci. Maybe due to incorrect IO or IRQ
|adresses. I have tried to start the with linux -noapic, but that did not
|make any changes I have also turned APIC off in the bios.
|
|One the system is up and running I have tried the following:
|
|insmod usb-ohci, but it does not work
|
|If I then do a "modprobe usb-ohci" everything works fine and i can mount
|the USB drives
|
|What is the difference between insmod and modprobe and why does it not
|work during startup, but ok once the machine is up and running????
- ---------------------------------------------------------------------
man insmod
man modprobe
If you have the USB 2.0 then try this:
Ref: file:/usr/share/doc/kernel-doc-2.4.19/usb/ehci.txt
Assuming you have an EHCI controller (on a PCI card or motherboard)
and have compiled this driver as a module, load this like:
~ # modprobe ehci-hcd
You can plave this in your modules.conf file which should work when booting up your computer.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.7 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQE9zW8cGmoP0nUBNzsRAiP/AJ9iW8B+5KUrbkVIhrLgz/Ayb2vXKwCeKwYX
XJo5MCSA65cja4k8XXB6Plw=
=e0pC
-----END PGP SIGNATURE-----
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
