On Sunday 20 July 2003 10:53 am, Rolf Pedersen wrote: > On Mandrake 9.1, with lm_sensors-2.7.0-2mdk, I have run > sensors-detect and accepted the default settings. The oddity is that > the sensors command, or gkrellm, or ksensors only show the value (at > least for temps, which is obvious) that exists at boot time. In > other words, first boot on a cool morning will show a relatively low > temp that does not change throughout the session. Subsequent boots > will show a, logically, warmer temp that, also, does not vary. This > has been the case from the stock kernel through the current > 2.4.21-0.18mm-mdk. I've just noticed the following message in syslog > and wonder if it suggests some clue to anyone? > > Jul 20 08:30:53 localhost kernel: i2c-ali1535.o: Resetting entire SMB > Bus to clear busy co > ndition (08) > Jul 20 08:30:53 localhost kernel: i2c-ali1535.o: SMBus reset failed! > (0x08) - controller o > r device on bus is probably hung > > > Rolf
Check out /usr/share/doc/lm_sensors-2.7.0/doc/FAQ, #4.11. I haven't messed with lm_sensors for a while, but can't you use the ISA bus for some chips? I think the option is mentioned during the sensors-detect routine. Good Luck, Arn
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com