Hi Carl-Daniel I got the 9.1 version from Ubuntu Synaptic.
I went to your website and downloaded flashrom-0.9.4.tar.bz2. I copied file to /home/barry in Terminal I did $ tar jxf /home/barry/flashrom-0.9.4.tar.bz2 This created /home/barry/flashrom-0.9.4 directory I then did cd /home/barry/flashrom-0.9.4 then # ./configure # make # make install These commands executed with no messages. When i do command flashrom -R I still see version 9.1. Any suggestions? Thanks Barry On Sun, Dec 11, 2011 at 8:54 PM, Carl-Daniel Hailfinger < [email protected]> wrote: > Hi Barry, > > it seems you're using a very old flashrom version. Could you please > retry with latest flashrom or at least version 0.9.4? That might fix the > issue you're seeing. > > Am 12.12.2011 01:19 schrieb Barry Krauter: > > Attempting to replace currbios with 661VS155.BIN upgraded Bios for > Shuttle > > 661V31 motherboard using 3com NIC card. > > > > Can you tell me why this fails? > > > > barry@baerry-desktop:~$ sudo flashrom -p nic3com -w > /home/barry/661VS155.BIN > > flashrom v0.9.1-r946 > > Found "3COM 3C90xB: PCI 10/100 Mbps; shared 10BASE-T/100BASE-TX" > (10b7:9055, BDF 06:02.0). > > Calibrating delay loop... OK. > > Found chip "SST SST39SF020A" (256 KB, Parallel) at physical address > 0xfffc0000. > > That flash chip is marked as supported in latest flashrom. > > Regards, > Carl-Daniel > > -- > http://www.hailfinger.org/ > >
_______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
