I'm not sure what you mean about setting High and Low Frequencies. You may already have the following settings but thought I'd pass mine along in case it helps. Think I got the info from a Flex Knowledge Base article a long time ago.
My settings in CWSkimmer, for 1000 Hz CW pitch freq would be; Under the Radio tab in skimmer; Hardware Type: SoftRock-IF CW Pitch, Hz: 1000 Audio IF, Hz: 10000 (9000 Hz default DDS IF freq in PowerSDR + 1000 Hz CW pitch freq) Sampling Rate: 48 KHz (this setting doesn't seem to make any difference) Under the Audio tab in skimmer; Soundcard Driver: MME (my PowerSDR VAC Driver setting) Signal I/O Device: 05 Virtual Cable 2 (my PowerSDR VAC Output setting) Audio I/O Device: 01 SB Live! Wave Device (my soundcard) Channels: Left/Right = I/Q Shift Right Channel Data by: 0 samples 73, Bill -----Original Message----- Date: Sat, 09 Jul 2011 21:29:22 +0200 From: Erik Jakobsen <[email protected]> To: [email protected] Cc: [email protected] Subject: Re: [FlexEdge] F5000A adn CWSkimmer Message-ID: <[email protected]> Content-Type: text/plain; charset=UTF-8; format=flowed Hi Dudley. I have, but thanks ;-) /Erik > Erik, > > Make sure that you have SR turned off. > > Dudley > > > > > ---- Erik Jakobsen<[email protected]> wrote: >> Hi. >> >> I'm setting up my Flex 5000A up to run with CWSkimmer. >> >> I have troubles getting it to work with 1000Hz as center frequency. >> If I in CWSkimmer click on the center of a CW station, the F5000A does >> not move to the >> 1000Hz center. >> What have I missed ? >> >> Setup is as follows: >> >> For 25Hz, the High frequency is set to 1012Hz and the Low frequency is >> set to 987Hz. >> >> That gives center at 1000Hz. >> >> CWSkimmer's pitch is set for 1000Hz. >> >> So are the Pitch Freq also in Flex 5000A. >> >> 73s - Erik - OZ4KK >> >> >> >> >> >> _______________________________________________ >> Flexedge mailing list >> [email protected] >> http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz >> This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
